Hydraulics: Guides
Getting Started
Pump water, boil your first steam and turn it into power.
Hydraulics adds steam power, fluid pipes and copper machinery. Almost everything runs on steam moved through pipes.
Your first steam setup
- Place a Copper Pump on top of a water source.
- Run a Copper Pipe from the pump into the side or bottom of a Solid Fuel Boiler.
- Put a separate pipe on top of the boiler. That's where steam comes out. Keep the water and steam pipes from touching, or they'll join into one network.
- Fuel the boiler with coal, charcoal, blaze rods, kelp or tar. One coal boils 4,000 mB of steam.
- Punch the pump to pump water by hand: 20 mB a stroke, about 100 strokes to get a boiler going.
Once a steam pipe touches the pump, it runs itself on a little of that steam (250 mB of water per tick for 25 mB of steam). With no steam it can run on Slimefun energy instead. Sneak to break the pump.
Making power
A Steam Turbine touching a steam pipe turns 100 mB of steam per tick into 64 J/s. That's enough to start running the pump on energy, or any other Slimefun machine.
Better boilers
| Boiler | Heat source |
|---|---|
| Solid Fuel Boiler | Coal, charcoal, blaze rods, kelp or tar |
| Lava Boiler | Lava piped into its sides. 1,000 mB of lava boils 12,000 mB of steam |
| Lightning Boiler | A Lightning Rod against it. Each strike stores heat for 50,000 mB of steam |
| Reactor Heat Exchanger | A running Slimefun reactor's spare heat, using no extra fuel |
Every boiler takes water in from pipes on its sides or underneath, and sends steam out of a pipe on top.